RACK MOUNTED VIDEO TRANSCEIVERS FOR TWISTED PAIRS
USING BALUN BALUNS TO TRANSMIT THE VIDEO SIGNAL OVER TWISTED PAIR WIRE
CABLE
rack mounted balun hubs in 9 and 18 inputs
A balun is a passive, non-amplified device
which allows video signals to be transmitted over unshielded
twisted pair, UTP, telephone cable. This means of video
transmission provides significant savings when compared to
traditional coax cable.
Using twisted pairs will bring cost savings
in several ways. Twisted pairs are less expensive than coaxial
wire cable. It may also be possible to use previously installed
telephone cables with unused pairs.. |
TWR-9 has 9 balun
inputs |
TWR-18 has 18 balun
inputs |
Range up to 2000 feet (600 meters) with
CAT5e UTP and over 1000 feet (300 meters)
with ordinary telephone cable
• Passive
device. No power supply required
• High
reliability and durability
•
TWR-9:
9 Inputs
TWR-18: 18
Inputs
TWR-9S & TWR-18S:
Surge Protected Models
|
The TWR series provides a convenient
rack-mounted
solution for multiple camera installations
using baluns to
transmit the video signal over twisted pair
cable. The
TWR-9 has 9 balun inputs, while the TWR-18
has 18.
Each input consists of a special type of
transformer which converts the video signal to a 75 Ohms
unbalanced output which can be connected to a coaxial cable
compatible with the input of any monitor, VCR or multiplexer.
Due to the excellent balance provided by
the TWR series the video signal will not affect or be affected
by other signals, even when they are transmitted in contiguous
pairs. You can transmit data, telephone signals or low voltage
power using neighboring pairs without affecting video signal
quality. Most of the electrical noise and RF interference which
affect coaxial cables are eliminated by the TWR series.
|
The UTP CAT5E wire cable, widely used in
computer local area networks, LANS, allows you to send signals
from 4 camera up to 2,000 feet [600 meters]. In addition to
reduced cost, it is easier t achieve a neat installation
compared to conventional CCTV installations with coaxial wire
cable. Also, splicing is much cheaper and faster compared to a
properly installed coaxial joint .
|
TECHNICAL SPECIFICATIONS –
TYPICAL VALUES
Frequency response:
DC to 12 MHz
Insertion losses:
max 0.5 dB at 5 MHz
Common mode rejection ratio:
≥60 dB from 15 KHz to 5 Mhz.
Impedance, coaxial side:
75 Ohms
Impedance, balanced side: :
100 Ohms ± 20%
Maximum signal voltage:
1 Vpp
Surge protection (S models only):
1.5V clamping voltage;
1.1 Amps surge current,;<1 nanosecond
clamping time.
|
|
WEB PRICING |
PART# |
DESCRIPTION |
WEB PRICE EACH |
TWR-9 |
RACK MOUNTED PASSIVE BALUN HUB
9 - inputs |
$329.00 |
TWR-9S |
RACK MOUNTED PASSIVE BALUN HUB
9 - inputs * WITH Surge Suppression* |
$359.00 |
TWR-18 |
RACK MOUNTED PASSIVE BALUN HUB
18 - inputs |
$489.00 |
TWR-18S |
RACK MOUNTED PASSIVE BALUN HUB
18 - inputs * WITH Surge Suppression* |
$549.00 |
balun, baluns, video, over, twisted, pair, wire, cable, wires,
cables, wiring, cabling, utp, cat, 5, cat5e, cat5, telephone, rack,
mount, mounted, mounts, mounting, 9, 18, input, inputs, hub, hubs,
surge, protection, suppression, price, prices, pricing, buy, cheap, low,
cost, twr-9, twr-9s, twr-18, twr-18s, stealth, laboratories, convert,
video signal, signals, 75, ohm, ohms,
*PRICES SUBJECT TO CHANGE WITHOUT NOTICE.
INVENTORY SUBJECT TO PRIOR SALE.
NOT RESPONSIBLE FOR ERRORS IN PRINT. Stealth
Laboratories, Trademarks, Patents and Copyrights are the Respective
Property of Stealth Laboratories.
Product Design & Specifications subject to
change without notice. Our Terms & Conditions of Sale apply to all
transactions. For a copy contact us.
© Copyright 2009 MidSouth Wire & Cable Co. All Rights Reserved.
|
|